NETWORK LAYER
INTRODUCTION
|
Question
[CLICK ON ANY CHOICE TO KNOW THE RIGHT ANSWER]
|
Are the commands “route print” and “netstat-r” basically the same?
|
|
Yes
|
|
|
No
|
|
|
Either A or B
|
|
|
None of the above
|
Explanation:
Detailed explanation-1: -Netstat ROUTe/-r report. Displays the routing information that this stack uses when it determines what addresses it can communicate with and over which links or interfaces and first hops the communication takes place.
Detailed explanation-2: -The-r option of netstat displays the IP routing table.
Detailed explanation-3: -Route Print allows you to see your computers routing table. That’s the table that your computer uses to decide if information on the network is addressed to it. The route command can also help your computer decide how to route packets when there are two directions that it can go to connect to other networks.
There is 1 question to complete.