NETWORK LAYER
INTRODUCTION
|
Question
[CLICK ON ANY CHOICE TO KNOW THE RIGHT ANSWER]
|
|
|
L-directly connected local interface IP address
|
|
|
C-directly connected network
|
|
|
S-static route was manually configured by administrator
|
|
|
O-OETI
|
|
|
E-EIGRP
|
Detailed explanation-1: -On a Cisco router, the show ip route command is used to display the IPv4 routing table of a router. A router provides additional route information, including how the route was learned, how long the route has been in the table, and which specific interface to use to get to a predefined destination.
Detailed explanation-2: -Router# show ip route. This command is used to show the IP routing table on the router. It details the network as known to the router and its sources for the information (such as the routing protocols).
Detailed explanation-3: -The ip-route command manages static routes in the routing table. Issue this command for each static route to add to the routing table. To delete a static route, use the no ip-route command. Issue this command for each static route to delete from the routing table.