NETWORK LAYER
INTRODUCTION
|
Question
[CLICK ON ANY CHOICE TO KNOW THE RIGHT ANSWER]
|
|
|
con t
|
|
|
configure terminal
|
|
|
config t
|
|
|
terminal config
|
Detailed explanation-1: -Initial command prompt “Switch>” appears on the screen. Type “enable” next to it and press “Enter". This will take you into the “EXEC” mode, also known as the Global Configuration mode. Go into configure mode using configure terminal.
Detailed explanation-2: -Global Configuration mode From the Privileged mode a user can move to configuration mode by running the “configure terminal” command from privileged mode. To exit configuration mode, the user can enter “end” command or press Ctrl-Z key combination.
Detailed explanation-3: -To enter global configuration mode, use the configure terminal privileged EXEC command. From privileged EXEC mode, use the configure terminal privileged EXEC command.
Detailed explanation-4: -Switch(config-line)# ? To exit line configuration mode and to return to global configuration mode, use the exit command. To exit line configuration mode and to return to privileged EXEC mode, enter the end command, or press Ctrl-Z.