NETWORK LAYER
INTRODUCTION
|
Question
[CLICK ON ANY CHOICE TO KNOW THE RIGHT ANSWER]
|
|
|
show run
|
|
|
show running-config
|
|
|
show all config
|
|
|
show ip route
|
Detailed explanation-1: -You will use the show running-config command in the simulation labs. You will use the show interfaces command in the practice labs. This command displays statistics for the network interfaces. Sample output from the show interfaces command is shown below.
Detailed explanation-2: -The show running-config command displays the current running configuration on the FWSM. You can use the running-config keyword only in the show running-config command. You cannot use this keyword with no or clear, or as a standalone command, because the CLI treats it as a nonsupported command.
Detailed explanation-3: -To display the contents of NVRAM (if present and valid) or to show the configuration file pointed to by the CONFIG FILE environment variable, use the show startup-config EXEC command.
Detailed explanation-4: -On a Cisco Wireless LAN Controller: Type “show run-config” to display the config.