COMPUTER NETWORKING

NETWORK LAYER

NEXT GENERATION IP

Please wait while the activity loads.
If this activity does not load, try refreshing your browser. Also, this page requires javascript. Please visit using a browser with javascript enabled.

If loading fails, click here to try again

Question [CLICK ON ANY CHOICE TO KNOW THE RIGHT ANSWER]

Which is the command to prompt out all IPv4 addressing?

A	Ipconfig
B	Ipconfig /all
C	Ipv6config
D	Ipv6config /all

Explanation:

Detailed explanation-1: -First, click on your Start Menu and type cmd in the search box and press enter. A black and white window will open where you will type ipconfig /all and press enter. There is a space between the command ipconfig and the switch of /all. Your ip address will be the IPv4 address.

Detailed explanation-2: -ipconfig/all: It gives the full configuration of the system. ipconfig/registerdns: This command refreshes all DHCP leases and reregisters the DNS names. ipconfig/displaydns: It displays the information that is stored in the DNS Resolver cache. It has all the DNS information that has been used earlier.

Detailed explanation-3: -Used without parameters, ipconfig displays Internet Protocol version 4 (IPv4) and IPv6 addresses, subnet mask, and default gateway for all adapters.

Detailed explanation-4: -Using ipconfig From the command prompt, type ipconfig to run the utility with default options. The output of the default command contains the IP address, network mask, and gateway for all physical and virtual network adapters. ipconfig/? displays the set of available options.

There is 1 question to complete.