NETWORK LAYER
UNICAST ROUTING
|
Question
[CLICK ON ANY CHOICE TO KNOW THE RIGHT ANSWER]
|
A network administrator is troubleshooting an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked What command will display the required information?
|
|
Router# show ip eigrp adjacency
|
|
|
Router# show ip eigrp topology
|
|
|
Router# show ip eigrp interfaces
|
|
|
Router# show ip eigrp neighbors
|
Explanation:
Detailed explanation-1: -The show ip eigrp neighbors command allows you to check the IP addresses as well as the retransmit interval and queue counts for the neighbors that have established an adjacency.
Detailed explanation-2: -EIGRP uses three tables: the neighbor table, the topology table, and the IP routing table. The neighbor table keeps state information regarding neighbors, and is displayed using the show ip eigrp neighbors command. EIGRP Update messages fill the routers’ EIGRP topology tables.
Detailed explanation-3: -Which of the following destination addresses does EIGRP use when feasible? (Choose two.) Explanation: EIGRP uses the multicast IP address 224.0. 0.10 or MAC address 01:005E:00:00:0A when feasible.
There is 1 question to complete.