NETWORK LAYER
UNICAST ROUTING
|
Question
[CLICK ON ANY CHOICE TO KNOW THE RIGHT ANSWER]
|
In which true statement EIGRP configure?
|
|
R1(config)# ipv6 unicast-routing.
|
|
|
R1(config-rtr)# ipv6 router eigrp 1
|
|
|
R1(config)# ipv6 router eigrp 1
|
|
|
R1(config)# ip router eigrp
|
Explanation:
Detailed explanation-1: -Which is true regarding EIGRP successor routes? A successor route is used by EIGRP to forward traffic to a destination. Successor routes are saved in the topology table to be used if the primary route fails.
Detailed explanation-2: -Configuring EIGRP 1 enabling EIGRP by using the router eigrp ASN NUMBER command.
Detailed explanation-3: -The above command enables EIGRP and puts us in EIGRP configuration mode. It needs only one parameter, an AS (Autonomous System) number. EIGRP uses an AS number to create a group of routers that can share routing information. You can choose any number from the range 1 to 65535 as an AS number.
There is 1 question to complete.