NETWORK LAYER
UNICAST ROUTING
|
Question
[CLICK ON ANY CHOICE TO KNOW THE RIGHT ANSWER]
|
What is the purpose of the 0.0.0.0 0.0.0.0 10.10.1.1 command?
|
|
To provide a default route for any non-matching network destination.
|
|
|
To create a dynamic route for the 10.10.1.1 network.
|
|
|
To create a static route for the 10.10.1.1 network.
|
|
|
To create a default gateway address for PC’s to forward packets.
|
Explanation:
Detailed explanation-1: -In IPv4-based routing, 0.0. 0.0 serves as a default route. This means no particular address has been designated in the routing table as the next hop in the packet’s path to its final destination.
Detailed explanation-2: -A default route is used for forwarding the packet when the switch can not find a match in the routing table for an IP packet.
Detailed explanation-3: -The default gateway is the path used to pass information when the device doesn’t know where the destination is. More directly, a default gateway is a router that connects your host to remote network segments. It’s the exit point for all the packets in your network that have destinations outside your network.
There is 1 question to complete.