NETWORK LAYER
UNICAST ROUTING
|
Question
[CLICK ON ANY CHOICE TO KNOW THE RIGHT ANSWER]
|
Which of the following commands should be used before configuring IPv6 routes?
|
|
router EIGRP
|
|
|
router OSPF
|
|
|
ip routing
|
|
|
ipv6 unicast-routing
|
Explanation:
Detailed explanation-1: -Before configuring a static IPv6 route, you must: • Enable routing by using the ip routing global configuration command. Enable the forwarding of IPv6 packets by using the ipv6 unicast-routing global configuration command.
Detailed explanation-2: -! ipv6 unicast-routing ! This command enables on IPv6 on just the device. It establishes an IPv6 routing table, allows you to configure IPv6 addresses on interfaces, and gives you access to the various IPv6 services the device can run.
Detailed explanation-3: -IPv6 Static Route Configuration To enable it, you can enter the command ‘ipv6 unicast-routing’ in the global configuration mode.
There is 1 question to complete.